Müller-ElektronikTractor ECU controller
In stock
The Tractor ECU is prepared for the use on utility vehicles and machines. The communication with a virtual terminal like Basic-Terminal, Basic-Terminal TOP or Comport-Terminal runs on the standardized CAN network (ISO 11783). The Tractor ECU is equipped with a 16-bit CPU card with Flash memory. Software updates and configuration files can be downloaded across CAN.
Actuators and sensors are connected to one up to three 42-pin connectors via a cable loop, which consists of corrugated tubes. Diagnostic functions are available for all in- and outputs, which are protected against short circuits to ground or operating voltage. The Tractor ECU supplies the power for the sensors at the 42-pin connectors. All inputs for revolution sensors can be configured for sensors switching operating voltage or GND.
Technical data
Tractor ECU
| CPU: | 16-bit Fujitsu MB90F345 with Flash-memory |
| Memory: | Flash 512 KiB; RAM 20 KiB; 64 KiB EEPROM |
| Connections: |
|
| Powersupply: |
10 VDC to 16 VDC or 19.2 VDC to 32 VDC (optional with switching power supply for 10 V to 32 V) |
| Current (Power On): | 350 mA (at 13.8 V without power output and power supply of external sensors) |
| Temperature range: | −20 °C to +70 °C (according to IEC 68-2-14-Nb, IEC 68-2-30 and IEC 68-2-14Na) |
| Housing: |
Closed aluminum box, varnished aluminum top with gasket, stainless steel screws |
| Protection category: | IP66K (according to DIN 40050-9 1993) |
| Environmental test: | Vibration- and impact test according to IEC 68-2 |
| Measurements: | 282 mm × 143 mm × 57 mm |
| Weight: | 0,95 kg |
| 16-pin plug |
|
| Second 16-pin plug |
Internal connection between 1st and 2nd 16-pin plug
|
| 42-pin plug | |
| Inputs: |
|
| Outputs: |
|